You need to dissipate around 200W of heat if you're running at 4.6 Ghz and your cooler has a TDP of 150W. You'll be throttling in any stress test with a Hyper 212 EVO on a 9900k. Nice and quiet and good enough for me! The black looks nice had the RGB fan hooked to my ASUS mobo rolls slowly through the colors.A Noctua NH-D15 on a 9900k maxes out in the 70's degrees with no OC. With a i9-9900K and a 4.6GHz OC, I can run the fan at low speeds and have the temp max out at around 70C.

It works fine as long as I don't go crazy overclocking the CPU.

It is certainly an improved method when compared to the 212 EVO, so progress has definitely been made.Johnpombrio said:I have the Hyper 212 EVO black edition which has a very similar mounting system. Once they are in place, secure the cooler by tightening down the four screws.Īfter that, all there is left to do is re-attach the fan – it just clips in to place.Īll-in-all, the Hyper 212 LED is very pain free to install. If they don't, make sure the installation screws on the cooler are also in the middle position. The screws from the mounting arms should align with the nuts we just installed. To do this, Cooler Master include a little screwdriver adapter (as above) for easy installation of the nuts.Īfter that, go ahead and mount the cooler. Flipping over the motherboard, pinch one of the screws coming through from the backplate – this will stop the backplate from falling out of position as you turn the motherboard over.Īfter that, you want to install the four nuts to the backplate screws. Next, go ahead and put the backplate in place. Before installing it, make sure the backplate screws are in the central position – it can be aligned in 3 places depending on the motherboard socket, and we want it to be in the middle. These just need to be screwed to the base of the heatsink, as pictured.Īs we are using a Z97 motherboard – LGA 1150 socket – we need to use a backplate. In the next step we see one change from the original 212 EVO – gone is the x-shaped mounting bracket that caused me such grief, and it has been replaced by two separate mounting arms. The fan is clipped in place – so just pry the clips from one edge free, and it should come loose. I remember building my first PC a few years back – I used the Hyper 212 EVO, and although it performed excellently for me, it was a nightmare to install for a first-timer.įirst things first, you need to just pop off the fan from the heatsink. The whole mounting mechanism has been revamped too, which should make the installation process nice and easy. As a disclaimer, we installed the 212 LED on a motherboard using the LGA 1150 socket.

Cooler master hyper 212 evo am4 install